Automatic CNC machine tool normal use must meet the conditions

2022-02-15 16:26

When using a fully automatic machine tool, the user is not allowed to change the parameters set by the manufacturer in the control system and change the machine accessories at will, such as the use of hydraulic chucks beyond the specifications. The setting of these parameters is directly related to the dynamic characteristics of each machine tool component. Only the value of the gap compensation parameter can be adjusted according to the actual situation, and blind replacement causes the mismatch of the parameters of each link, and even causes less than estimated loss. Automatic machine tool equipment


The position of the machine tool should be far away from the vibration source, should avoid the influence of direct sunlight and thermal radiation, and avoid the influence of moisture and airflow. If there is a vibration source near the machine tool, the anti-vibration ditch should be set up around the machine tool. Otherwise, it will directly affect the machining accuracy and stability of the machine tool, and will make the electronic components in poor contact, failure, and affect the reliability of the machine tool.


The ambient temperature of the automatic lathe is less than 30 degrees, and the relative temperature is less than 80%, otherwise it will affect the processing accuracy, and even cause short circuit, and reduce the service life of each component. In general, the automatic lathe CNC electric control box is equipped with an exhaust fan or chiller to keep the electronic components, especially the central processor, at a constant operating temperature or a small temperature difference. Excessive temperature and humidity will lead to reduced life of the control system components and lead to increased failure. The increase in temperature and humidity, the increase in dust will produce a bond in the integrated circuit board, and lead to short circuit.